RCV引擎正時
一時手養 想一探此引擎奧妙 於是拆了引擎(RCV58CD) 但回裝時才驚覺忘了標示正時位置 查了原場網站 不是圖看不清就是豆牙菜看不太很懂 請問有無同好有此一經驗 不吝分享 感恩再感恩~ RE-ASSEMBLING YOUR ENGINEReassembly is a simple operation & the main difficulty is ensuring that
the gears are engaged in the correct position so that the engine is timed
correctly.
1. Carefully remove any bearing lock material from the back bearing and
the crankcase halves.
2. Assemble the crankshaft piston assy in reverse order.
3. Take the cylinder jacket and rotate the cylinder until the cylinder port is
equally visible in the exhaust and inlet ports.
4. Now insert two cocktail sticks (or similar) into the exposed segments of
the port to lock the cylinder in position. Insert the piston into the
cylinder bore and engage the gears in such a way that the piston is at
top dead centre checking that the crankshaft webb is horizontal.
5. Apply a small amount of bearing lock onto each bearing and assemble
the bottom half of the crankcase with the six screws. Do not over
tighten these screws.
6. Remove the cocktail sticks.
有意思!! 要不要讓我試試?免費!!
0932-019-838 引擎活塞轉到上死點
然後 旋轉區軸
眼睛從 化油器 跟 排氣管兩邊都有光線(兩邊大小一樣)
怕跑掉用束帶穿過去
希望對你有幫助
[ 本帖最後由 CFI-MASON 於 2010年5月6日 09:20 AM 編輯 ] 感謝三哥的熱情 還有CHI-MASON的圖解 目前已裝置完畢 待回家後再啟動試發 感謝再感謝各位大仔 GOOD LUCK 我喜歡追根究底的人... 再請一問大仔 副油針原廠設定約多少